1 Mbps Coaxial Transceiver AFE

₹12500-37500 INR

Posted 1 minute ago

•

Ends in 6 days

₹12500-37500 INR

Paid on delivery

I need a complete analog front end for a half-duplex transceiver that shifts a 1 Mbps manchester data stream onto, and off of, a single coaxial cable linking two electronic devices. The job is purely wired—no radio, no optics—so every design choice must suit standard 78 Ω (or other industry-common) coax and allow direction switching on the same line. Detailed spec document from standard is attached. Refer 50.3 till end. What I expect from you: • A driver stage that delivers a clean, logic-level-compatible signal onto the cable while meeting return-loss and termination requirements. • A receive stage with the necessary filtering, equalisation (if helpful at this data rate), and level restoration so the digital logic that follows sees reliable edges. • A simple method of enabling half-duplex turnaround (for example, a TX-enable pin or comparable control) that can be tied into my existing FPGA/µC firmware. • Schematic in a neutral format (PDF plus either KiCad, Altium, or LTspice source), a concise bill of materials with currently available parts, and simulation plots that prove the link margin at 1 Mbps over representative coax lengths. • Brief design notes explaining impedance considerations, component tolerances, and any PCB layout constraints I should observe before routing the final board. If you already have SPICE, ADS, or similar modelling tools in place this should move quickly; please build and hand over the simulation so I can re-run it on my end. The focus is robustness and clarity, not exotic data rates, so keep the solution practical and component-sensible.

Project ID: 40821194

About the project

Open for bidding

Remote project

Active 57 yrs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅