Digital Stopwatch Design Using Discrete Logic – Urgent -- 3

$8-15 USD / hour

Posted 1 minute ago

•

Ends in 6 days

$8-15 USD / hour

I’m looking for an experienced digital electronics engineer to design and simulate a digital stopwatch using exclusively discrete logic, flip-flops, and logic gates. **Technical Requirements:** - Display format: MM:SS (00:00–59:59) using four 7-segment displays. - NE555 astable clock generator (1 Hz) with LED indicator (±10% tolerance). - Start, Stop, and Reset buttons with debouncing circuits. - Four custom counters: seconds units (modulo 10), seconds tens (modulo 6), minutes units (modulo 10), and minutes tens (modulo 6). - Correct carry propagation between counters. - BCD-to-7-segment decoding. - 5V DC power supply. **Restrictions:** - No Arduino, ESP32, PIC, or other microcontrollers. - No integrated counter ICs (74LS90, 74LS393, etc.). - All counting logic must be built using flip-flops and logic gates. **Deliverables:** - Video recording showing the construction process and the stopwatch working correctly. Simulation and circuit design are completed in my side and the only thing I need is this video. No time to order components or buy them, **Important:** Physical delivery is NOT required. Components can be reused after recording. I only need the design, simulation, and video evidence of the actual prototype being built and working. **Deadline: URGENT – The entire project must be completed today.** Please apply only if you have solid practical experience with digital electronics and can meet the deadline.

Project ID: 40820919

About the project

Open for bidding

Remote project

Active 57 yrs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅