Design Compact IoT Control PCB
$250-750 USD
Posted less than 20 seconds ago
•
Ends in 6 days
$250-750 USD
Paid on delivery
I want a small, production-ready PCB that can take sensor inputs, drive loads, and sit comfortably inside a tight enclosure. Its primary role is to control three kinds of outputs: LED strips or other low-voltage lights, DC motors or pumps, and relay-isolated mains equipment. Connectivity must be flexible. Please integrate Wi-Fi for local network control, Bluetooth for provisioning or short-range commands, and a SIM-based mobile link (LTE-M, NB-IoT, or 2G fallback) so the board stays reachable where Wi-Fi is absent. An onboard antenna or [login to view URL] connector that keeps the layout compact is preferred. The form factor should stay under roughly 50 × 50 mm if practical, with careful separation of high-voltage relay traces from low-voltage logic. Low standby current is important, yet the design still has to source enough current to switch relays and drive small motors without external drivers. I am open to proven MCU families such as ESP32 or STM32 + ESP-AT, as long as the chosen parts meet the connectivity mix and have solid toolchain support. Deliverables • Complete schematic (PDF + editable CAD) • PCB layout files and Gerbers ready for fabrication • Bill of materials with manufacturer part numbers and current availability notes • Basic firmware stub or pin mapping that demonstrates Wi-Fi, Bluetooth, and cellular links coming up and driving each output line • A brief design note explaining power domains, antenna clearance, and any certification considerations (CE/FCC pre-scan points) I will review the schematic first; once it is approved, proceed to layout, then final checks before we order a prototype run.
Project ID: 40820862
About the project
Open for bidding
Remote project
Active 57 yrs ago
Place your bid
Bid amount Email addressBenefits of bidding on Freelancer
Set your budget and timeframe
It's free to sign up and bid on jobs
内容来自 Freelancer News,版权归原作者所有。
阅读原文 ↗