Gamepad Pico & Gyro Hardware Mod

£10-20 GBP

Posted less than 10 seconds ago

•

Ends in 6 days

£10-20 GBP

Paid on delivery

I need my wired GameSir Tegenaria Lite opened, fitted with a Raspberry Pi Pico and two MPU-6050 gyro sensors exactly as shown in the alpakka-lite guide ([login to view URL]), then closed up so the pad still looks stock. The one visible change I do want is a pair of small capacitive-touch patches on the top edge—one beside each shoulder button. Each patch is simply a 3 mm hole with a wire looped through and secured under conductive tape, the free end going to an unused Pico GPIO, identical to the touch point in the original wiring diagram. I will hand you: • the controller • the Pico (pre-headers) • two gyro boards • conductive copper tape • resistors, screws, tape, hot-glue sticks and solder Please bring only the thin, flexible stranded wire needed for the internal runs; everything else is covered. After assembly I’ll flash the firmware myself, so the deliverable is the fully re-assembled pad that: 1. powers over USB without extra draw, 2. exposes both gyros on I²C, and 3. shows a clean capacitive reading when each touch patch is pressed. Let me know your labour cost and approximate turnaround. Local hand-off or tracked postage both work for me.

Project ID: 40816873

About the project

Open for bidding

Remote project

Active 57 yrs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅