Modular 3D-Printable Humanoid Robot Frame

₹12500-37500 INR

Posted 1 minute ago

•

Ends in 6 days

₹12500-37500 INR

Paid on delivery

Design a modular, 3D-printable humanoid robot frame (torso up). It must be easy to assemble, service, and wire. Deliverables must be .STEP (for editing) and .STL (optimized for FDM printing). Electronics to Accommodate: 7x MG996R Servos (Standard 40x20x36.5mm size). 1x Raspberry Pi 5 (with room for active cooler). 1x 7-inch HDMI Display (with driver board). 1x 2-inch speaker and 1x USB microphone. 1x NeoPixel LED Ring. 1x Servo Power Supply (Dimensions: approx. 100x60x30mm). Mechanical Requirements: Head (2 DOF): Pan/Tilt using 2 MG996Rs. Must include a snap-fit or screw-in bezel for the 7" display. Include mounting points for the speaker/mic. Torso (2 DOF): A "waist" mechanism using 2 MG996Rs to provide twist and lean. Arms (2 DOF each): Shoulder and Elbow joints. Servo Mounts: Do not print flexible joints. Design rigid, screw-together servo housing blocks that clamp around the MG996Rs. Use standard 25T servo horns and bearings for pivots. Cable Routing: Include 6mm to 10mm internal channels for servo cables to pass from the arms/head down to the lower torso. Assembly: The torso must be split into a front and back half (clamshell) so the electronics can be installed easily. Design Rules for 3D Printing: Minimum wall thickness: 2.5mm. Parts must print without supports where possible, or with supports that are easy to remove. Use heat-set threaded inserts (M2 and M3) for all screw connections. No self-tapping screws into plastic. Allow 0.2mm clearance for all moving parts.

Project ID: 40815350

About the project

2 proposals

Open for bidding

Remote project

Active 19 secs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

2 freelancers are bidding on average ₹23,750 INR for this job

User Avatar
Flag of INDIA

You need a modular, 3D-printable humanoid robot frame designed for assembly and electronics integration. Trygve Studio's expertise is architecture, interiors and product development, with a team of architects, engineers and 3D visualizers. We will approach this project by developing the mechanical housing in SolidWorks to meet your specified dimensions and assembly requirements. Please view our profile and message us to discuss the details.

User Avatar
Flag of PAKISTAN

Hello, I’m a product designer with 5 years of experience in 3D CAD and 3D modeling, with a strong focus on functional, assembly-friendly mechanical design. I’ve worked on parts that need to be printable, serviceable, and precise enough for real hardware integration. I understand you need a modular humanoid robot frame that cleanly fits the listed servos, Pi 5, display, audio components, and power supply, while staying easy to wire and maintain. I would design the torso as a split clamshell, use rigid screw-together servo housings, add internal cable channels, and prepare the assembly with proper clearances, heat-set insert locations, and FDM-friendly geometry in both STEP and STL formats. I’ll keep communication clear throughout the project and make sure the design stays aligned with your assembly and printing requirements. I’d be excited to discuss the details and get started. Regards

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅