Repair Architectural STL For Printing

$10-30 USD

Posted less than 20 seconds ago

•

Ends in 6 days

$10-30 USD

Paid on delivery

I have an STL of an architectural model that should look like a miniature building once printed, but the mesh currently contains holes and other non-manifold errors that stop my slicer from generating clean G-code. A few sections also need slight reshaping so they print without crumbling or requiring excessive support, yet the overall look and proportions must remain faithful to the original design. Your task is to open the STL in the tool of your choice—Blender, Meshmixer, Netfabb, Fusion 360, or similar—identify and close every gap, resolve flipped normals, decimate only where it helps the file size, and adjust any areas that are obviously too thin for FDM printing. I do not need a total redesign; just make the mesh watertight, strengthen fragile spots where practical, and return a file that slices error-free at 0.2 mm layer height. Deliverables: • Clean, watertight STL ready for printing • Screenshot or brief note of the main repairs performed I have attached two screen shots. One is a round dome on top of the building. It is hanging off the edge. I need that adjusted either smaller or moved so it doesn't go over the edge. The second is a picture where the wall needs to be extend down so there isn't a gap at the bottom. I will verify the result by running it through bambu studio and a mesh check tool, so please be sure there are no remaining red flags. If everything slices smoothly, the job is done.

Project ID: 40812127

About the project

Open for bidding

Remote project

Active 57 yrs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅