Stabilize RS485 Board Communication

₹600-1500 INR

Posted 1 minute ago

•

Ends in 6 days

₹600-1500 INR

Paid on delivery

My in-house RS485 board starts dropping frames and throwing checksum errors as soon as I hook up more than one slave on the bus. With a single device everything is perfect, so I strongly suspect a hardware issue—possibly biasing, termination, or the way the transceiver’s DE/RE lines are handled. The wiring in the field is a backbone with short branches to each node, so reflections can appear if the board is not designed for that topology. I need a hardware-focused engineer who can dive into the schematic and PCB, pinpoint the weakness, and deliver a proven fix. You’ll have remote access to scope traces and logic-analyzer captures, and I can ship a unit to you if hands-on testing is required. Acceptance criteria • Board communicates error-free with at least four nodes on the branched line at 115 200 bps. • Updated schematic and PCB files (Altium or KiCad) showing the correction, plus a short note explaining the root cause and how it was solved.

Project ID: 40804507

About the project

2 proposals

Open for bidding

Remote project

Active 11 secs ago

Place your bid

Bid amount Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

It's free to sign up and bid on jobs

2 freelancers are bidding on average ₹1,025 INR for this job

User Avatar
Flag of UNITED KINGDOM

With one slave fine and several failing, I'd check three things first: bias and termination only at the two physical ends of the bus, stub length on the branches, and whether DE/RE switches off right after the last stop bit. A slow optocoupler on the TX or DE path can also distort edges at 115200. I'll go through your schematic and PCB, fix the cause, and send updated files with a short root-cause note. I've done a lot of Modbus RS-485 and industrial interface work.

内容来自 Freelancer News,版权归原作者所有。

阅读原文 ↗

把喜欢的内容,留在你的新标签页。

打开我的订阅